Hurley 27 Cutter Rig

Hurley 27 Cutter Rig
contact me about this boat
watch this boat in My Boatshed
send this page to a friend

Hurley 27 Cutter Rig

Boat REF# 132511
Price
Reduced
LOA 8.23m (27'0")
Year unknown year
Construction GRP
Underwater profile Long keel
Berths 4
Engine 1 x diesel 13hp, Volvo MD7A (unknown year)
Lying Plymouth
Make an offer

Contact the Broker

Boatshed Broker Stephen Grimshaw
Telephone +44(0)1752 426 106
Email boats@boatshedplymouth.com

I want to see full spec & up to 80 photos of this boat,register me now

Extra Details

Designer Ian Anderson
Builder Hurley Marine
Lying Plymouth
Fuel capacity 1 x 45.5 ltr (10.0 G)
Water capacity 1 x 45.5 ltr (10.0 G)
Holding tank capacity 0 x 0.0 ltr (0.0 G)
Last survey Not Recorded

Mechanical

Engine 1 x diesel 13hp
Volvo MD7A (unknown year)
Engine Hours Not Recorded
Engine Cooled Raw Water
Steering Tiller
Drive Shaft
Prop(s) 3 blade bronze
Fuel consumption (approx) Not Recorded
Cruising speed (approx) Not Recorded
Max speed (approx) Not Recorded
Engine serviced at Blagdons 2011
New electrics panel
New Rev counter
New upholstry
New running rigging
New windows
Sea cocks serviced 2011

Dimensions

LOA 8.23m (27'0")
LWL 6.30m (20'8")
Beam 2.26m (7'5")
Draft Min 1.22m (4'0")
Draft Max 1.22m (4'0")
Displacement 3,000kg (6,615.0lbs)
Headroom 1.78m (5'10")
Storage Ashore

Rig

Cutter rigged Aluminium spars (1976), with stainless steel standing rigging (2011)

Sails

Mainsail - Slab (unknown year)
Headsail - Hank on (2011)
Halyard winches 1
Sheet winches 4
Other sails Staysail (unknown year)
Spinnaker (unknown year)

Electrical Systems

12 volt, 2 batteries charged by: engine

construction

GRP construction with Long keel underwater profile, paint finish

Accommodation

Cooker tick Grill tick
Oven tick Sink tick
Manual water system tick Fresh water wash tick
Non-Smokers tick    
Handbasin 0
Shower 0
Heads 1 heads (Vac flush)
4 berths with 1 doubles and 2 singles in 2 cabin(s) 2 burner gas cooker

Nav Equipment

Compass tick Log tick
Echo sounder tick VHF tick
Autopilot tick Clock tick
Barometer tick Navigation lights tick

Deck Gear

Cockpit cover tick Warps tick
Fenders tick Boathook tick
3 anchors
(CQR and Danforth)
20.00m (65'7") of chain
20.00m (65'7") of warp

Safety Equipment

Life buoys tick    
1 bilge pumps (1 manual / 0 electric)

Broker's Comments

Register with Boatshed to see 45 extra photos of this Hurley 27 Cutter Rig.
Here is a great opportunity to put the finishing touches to this Hurley 27. Most of the work has already been done and there is lots of new inventory and equipment already installed. With a little bit of work and a good external clean she would be ready to go to sea again.

These boat details are subject to contract.
Note: Offers on the asking price may be considered.

This Hurley 27 Cutter Rig has been personally photographed and viewed by Stephen Grimshaw of Boatshed Plymouth. Click here for contact details.
Disclaimer
The particulars detailed herein are intended to give a fair description of the vessel but their accuracy cannot be guaranteed, these particulars are not a part of any contract or offer and are supplied on the understanding that all negotiations shall be through Boatshed Brokerages, who are acting as brokers for the vendor. The vendor is not selling in the course of a business unless otherwise stated. The prospective purchaser is strongly recommended to check the particulars and where appropriate, at his own expense, to employ qualified agents to carry out surveys, structural and/or mechanical & electrical.
Feedback Form